Tying in a Peep Sight.

First install the peep in the string using the side grooves. Then start serving the same way you would do your center serving. Approximately 1 and 1/4 inch above the peep, continue for 1/4 inch.

Wrap the serving around one side of the bow string three or four times. When you get to the peep start wrapping the serving around the serving center groove of the peep.

Wrap the serving around the center groove three or four times.

Stop wrapping on the opposite side from which you started. Take the serving and go around the string once above the peep. Pull the serving tight and then wrap the serving around the other side of the bow string three or four times. At about 1 inch below the peep finish by back serving in the same way you would finish your center serving.

You now have a correctly tied in peep.

This is a method of tying in your peep sight. This method will work for any type of peep. Only difference is on some style of peeps you will have to tie in one section above and one section of serving below. The serving will not wrap around the peep. If you have any questions about how to do this properly, you can contact me on the forum and I will try to help clarify it for you. When I come up with a better way of showing this I will update this page. If you do not have serving thread dental floss will work quite well.